Setting Stringline – Tight Radius
When placing string line pines on the corners, they must be placed at an equal space apart and close enough to make the string line look round. If the pins are not spaced equally apart, the machine tracks will not a consistent radius resulting in the machine tracks hunting and not staying square with the radius and may result in an unround corner.
Some machines such a 1 track steer machines, you are able to stretch the “T-pin” spacing, however, it is important that the machine keeps turning when going around the radius. The front track may “hunt” while going around but 1 track steering machines take 10+ feet to straighten out while all track steering machines can straighten out within 2ft.
All track steer machines require that the line is as round as possible as these machines can straighten out within 2ft, it is important to keep these machines turning a consistent radius.

T-Pin Spacing
It is important when setting pins in a tight radius that the first and last pin in the radius be used as a buffer for the sensors. This means that the first adjustment the machine makes into the radius is a minimal turn to minimize the reaction of the sudden change from entering a radius. This results in a smoother turn, easier on the machine and a nicer radius.
Improper Radius Stringline Setup

As you can see by figure 2, some radius, if not set properly the machine will have a sudden turn when entering the radius and this takes away from the goal of turning a consistent radius as the machine will now struggle to find its position around the radius. We have added a green line to show what this radius should have looked like to produce a consistent turn. It is possible to turn a radius set up like this however it requires a second person to watch your sensors and creates a lot of other problems such as more work for the finishers.
Fiberglass
Using a fiberglass rod will eliminate 50%-70% of the pins used in all radii. It also cuts down on the amount of manpower and time it takes to set up a radius. The most important benefit of using fiberglass is that it gives the machine a consistent and smooth turn creating a better product behind.
You can also use fiberglass rods without the special clips, simple tape the fiberglass rod to the pins and line, this adds the extra benefit of having a smooth turn around the radius.

Why You Should Always Paint Out Your Line on Radii

Painting out your line has several benefits such as seeing where your curb and line will be but when you go to install your pins you will have your line already painted out, avoiding the problem of moving pins later on when you realize you have put them too close. For the extra 3$ in paint and only putting pins in the ground one time, this may be worth the extra 5 minutes.