BBCW

Tie Offs

When putting your tie off pins into place, you must offset these pins compared to the rest of the line. This is to help the machine operator when pulling on and off the line so he does not damage his sensors on the tie off pins when pulling on and off the line. You must NOT offset these pins more than a few inches or it will put to much pressure on the line and pull back your starting and last “T-Pin” back and off grade.

Proper Tie Off

Figure 1 – Proper Tie off

Improper Tie Off

Figure 2 – Improper Tie Off

Putting your tie off pin too far back will result in very high pressure put onto the first grade T-pin and may pull it back off grade.

Parking Lot Corners

Figure 3

The BLUE line should be placed on top of the RED line. When the machine enters this corner, you will need to LOWER (DO NOT undo) the RED line so that the machine can drive over the line and you can continue to pour tight into the corner.

You can pour until your mold touches the RED line so that you pour as tight as possible into the corner saving your finishers lots of work and saving the company lots of money by finishing the tie in on the go. This is only possible is the grade behind the line is acceptable and not a deep ditch. A small ditch, small pile, mud you can still track over, you do not need to prepare behind the line, the machine will account for this change assuming you have placed the front grade near the front of the hopper.

Figure 4

When the machine is approaching the corner, the RED line (Figure 1) can be dropped and the machine can run over the line by placing the line into the trackpad grove/slot (Green) and NOT between trackpads (RED) as this would cut the line as seen in figure 5.

This image has an empty alt attribute; its file name is line-drop.jpg
Figure 5

Corner Tie Offs

The tie-off pins for corners should be installed differently than straight sections. You want to be able to use the line for the steering sensor as much as possible when trying to pour tight into the corner minimizing the risk of having a crooked corner. You can place this tie off inline with the rest of the line and not offset as it is not in the way of the sensors as seen in figure 3 and figure 6.

Figure 6
Last updated on March 23, 2020
1101 reads
Picture of Brandon Gambini

Brandon Gambini

Gambini Consulting

Leave a Reply

Help us to make this resource even better, please take a few minutes to take the survey!

CONTACT US

Copyright © 2010-2026 Gambini Consulting | Reproduction without expressed written permission is forbidden.

Website designed and maintained by Gambini Consulting

Scroll to Top