BBCW

Setting Stringline – Inline Tie Offs

Inline tie-offs are extremely important and should be apart of every run of string line over 300m long, including radii. They have several benefits that include if a section of line breaks for various reasons, the most common being a finisher untied a section of the line without paying attention, a truck backing into the line and the line break from being overstretched or old a tie-off will save a section of line for you, hopefully, the section you are now pouring and you won’t need to stop to repair the line.

Figure 1

These tie off pins DO NOT need to be more than 6″ behind the string line as this will put added pressure onto the t-pin at the grade where the tie-off is taking place and could cause this t-pin to be off-grade causing several problems.

When And Where To Install Inline Tie-offs

These should be installed on EVERY line that is over 350ft (100m) in length. You can put them closer, it will not hurt anything except take some extra time to install. They should only be placed at catch basins or other obstacles that force you to stop pouring or to pull off of the line. The reason for this is there is a lot of pressure on this t-pin supporting the tie off and may result in the pressure pulling the t pin back and off grade. By putting these at obstacles, if there is a problem it can be corrected somewhere you need to form or make a correction anyway.

You can also place these on radii, preferably at catch basins, however, not necessary on radii as you will not need to worry about a straight alignment.

Low Tie Offs

https://www.youtube.com/watch?v=WqUm7jqNi8A

If you are running your sensors below the line, these string lines must be tied off above the main string line you are using. If you do not do this, the sensor will grab the tie off string line and it could cause the machine to drive into the ground as see in the video below, causing you to either get caught in high gravel or causing a big hump behind the machine.

https://www.youtube.com/watch?v=jmiFu45KJuY
Figure 2a

Correcting this mistake and the sometimes unavoidable situation is easy, you simply use a t-pin to prop up the line if you’re running your sensors below the line as seen in figure 2b and in figure 3 below.

Figure 2b

Continuing The Stringline

Figure 3

You DO NOT need to cut this tie offline to continue the string line as you see in GREEN in figure 1 and in WHITE in figure 3 we have continued this line from one tie-off pin to the other and continued our string line. Avoid cutting your line as much as possible.

Last updated on March 23, 2020
1140 reads
Picture of Brandon Gambini

Brandon Gambini

Gambini Consulting

Leave a Reply

Help us to make this resource even better, please take a few minutes to take the survey!

CONTACT US

Copyright © 2010-2026 Gambini Consulting | Reproduction without expressed written permission is forbidden.

Website designed and maintained by Gambini Consulting

Scroll to Top