Setting Stringline (Straight Line)
When setting straight lines, it is always best to go from A>B and not worry about the offsets in between.
When going from A>B you ensure that the line is straight between those points. The surveying is not always perfect and can be out sometimes, it’s your job to minimize this and make a straight product.
As you can by our GREEN line, our start and finish line up perfectly, but our middle offsets are out a little bit. If we followed these offset we would have a product that was no longer straight.
When setting line, you see need to double-check these offsets and see how far off they are and it is important that you alert the surveyors or inspector of the change you have made and see if they approve of it.

Tie Offs
When putting your tie off pins into place, you must offset these pins compared to the rest of the line. This is to help the machine operator when pulling on and off the line so he does not damage his sensors on the tie off pins when pulling on and off the line. You must NOT offset these pins more than a few inches or it will put to much pressure on the line and pull back your starting and last “T-Pin” back and off grade.

Improper Tie Off

Putting your tie off pin too far back will result in very high pressure put onto the first grade T-pin and may pull it back off grade.
Middle T-Pins
When putting “T-Pins” into the ground always make sure they are NOT further apart than 10ft for curb, barrier and sidewalks. For paving these “T-Pins” can be placed up to 20ft apart. This difference in distance is because of the sensor locations on the machine. Curb machines have sensors that are 60% closers than a paving sensor setup when puts more pressure on the line and we need to account for that added pressure or you will have a wobbly curb both sideways and up and down.